TY - JOUR ID - 32582 TI - Fluorosilaned-TiO2/PVDF Membrane Distillation with Improved Wetting Resistance for Water Recovery from High Solid Loading Wastewater JO - Journal of Membrane Science and Research JA - JMSR LA - en SN - AU - Mohd Yatim, Nur Suhaili AU - Boon Seng, Ooi AU - Abd. Karim, Khairiah AD - Universiti Malaysia Perlis AD - Universiti Sains Malaysia Y1 - 2019 PY - 2019 VL - 5 IS - 1 SP - 55 EP - 64 KW - Membrane Distillation (MD) KW - Fluorosilane KW - Thermal Efficiency (TE) KW - Wetting KW - High solid loading wastewater DO - 10.22079/jmsr.2018.89172.1202 N2 - Membrane distillation (MD) has emerged as an important technology for applications in industries such as seawater desalination and wastewater treatment due to its low energy requirement and theoretically low fouling propensity. However, the main obstacle to obtain high separating efciency in MD lies on the availability of porous hydrophobic membrane that can withstand pore wetting and membrane fouling. In this work, a dual coagulation bath method was introduced to alter the membrane morphology by increasing its porosity, surface roughness as well as polymer crystallinity. To increase the membrane hydrophobicity, membrane roughness was induced by adding TiO2 nanoparticles. However, this has brought concomitant impacts by lowering its porosity due to the pore blocking and reducing hydrophobicity due to the presence of hydroxyl group on TiO2 surface. Introduction of silanized TiO2 modifed at pH 7 gave higher contact angle (131.7±4) that could withstand the pore wetting and at the same time maintained its high permeation flux (12kg/m2.h) and excellent nutrient removal efciency of 99.65%. Consistent flux around 6 kg/m2.h for Paper Mill Sequence Batch Reactor (PMSE) could be achieved showing that the membrane wetting and fouling resistance towards solids were good. The system efciency was around 55% which was comparable to the pure water treatment process (50%). However, the membrane was not suitable to be used for treatment of the oil-rich Palm Oil Mill Efuent (POME) as the flux dropped from 6 to 2 kg/m2.h after 7 hours of operation with thermal efciency dropped to 26% due to fouling phenomena. UR - https://www.msrjournal.com/article_32582.html L1 - https://www.msrjournal.com/article_32582_5d3573e839f49c8c89ce83db680524d6.pdf ER -